PatrickMead#13 (Offline)
#1
11/28/12 2:21 PM
I was thinking of putting a second car together for my dad to try it. He's a big guy so I know my car was out. I was thinking of machining a spacer to move the sprocket outside the frame rails from the counter shaft so he could get all the cockpit room as possible by moving the chain outside the car bit still keeping the engine where the rules specify. Is anyone else already doing this setup or similar deal? The only thing I'm thinking might be the fly in the ointment is the counter shaft bearings in the block. Or I thought of doing a dwarf car driveshaft to a quick change and sealing off the shaft in the cockpit seams as the motor already has a hawk driveshaft adaptor on it.
Posted via Mobile Device
PatrickMead#13 (Offline)
#5
11/28/12 6:01 PM
Same setup as a propane refrigerator in most campers. Very small amount of ammonia will do it
Posted via Mobile Device
Bradleyracing86 (Offline)
#7
11/28/12 7:40 PM
I've got a chassis that will accomadate a 17" seat.
Posted via Mobile Device
PatrickMead#13 (Offline)
#8
11/28/12 10:56 PM
Got any pics?
Posted via Mobile Device
Bradleyracing86 (Offline)
#10
11/29/12 11:24 AM
Sure float me your email.
Posted via Mobile Device