[jdull99]

-12 mid-90s era Gaerte Engine; For sale or rent.

Ok for indoor racing!!! ...Indy, DuQuoin, Ft Wayne, Tulsa...(still legal POWRi, ARDC, etc. too!)

100% FRESH...everything was in the works to run it with local clubs, but now it appears I'd have to tow 3hours+ to run it anywhere in any form...

BRAND NEW rings, bearings, gaskets, valve springs, rod bolts, etc. Lifters, rockers, etc were recently updated.

All the standard professional racecar engine builder procedures: "Surgically" clean (lol), Magnetic Practical Inspected (all the parts that are steel...lol), blue-printed (crank, rods, valve stems & guides, align-bore, valve spring height, valve to piston clearence, etc, etc. measured to spec - NOT assembled with "plasti-gauge"!), cylinders honed, block & head surfaced, piston-pins fitted, rings "gapped", "competition valve job", etc, etc. (if I didn't list it, just ask!)

$599 to rent per track day. EVERYTHING available to install in your car: oil pump to motor plate (narrow-body Stealth), air-filter to pan. All fuel set-ups & oil lines. Supported at fire-off & track-side.

$4599 to buy out-right un-assembled.

$5699 to buy professionally assembled.

Come check it out now; to see exactly what you would be getting. I would LOVE to see this engine on track again after all the time, effort, money, etc. put into it...

[jdull99]

Still available...a VERY good time to put your eye on this while it is still apart & you can see what you are getting! Let's make a deal!!! Located 90miles west of Chicago, right by Rockford Speedway.