ride height adjustment

diana · 7/4/13, 12:34 AM

Hello ,
Can anyone out there tell me the procedure for setting ride heights
I am using 21/2 blocks in the front and 23/4 left rear 23/8 right rear
I put the blocks between the axle and the bottom rail , loosen off the torsion stop bolt until it just touches
After I do this to the four corners I check my ride height not sure if this is right but I measure from the ground up to the bottom of the frame rail
Now if this is correct my ride height is to tall and I have to start turning torsion adjuster bolt to try and lower the car but it is already as low as I can get it
Plus how and when do I start adjusting corner weights I have heard you should have 100 lbs more in the left front than the right front and the back should be close to equal.
Bailey chassis. Any help would sure be helpful. Hope to hear from someone who knows mini sprint setup
Thank you

Posted via Mobile Device

cecil98 · 7/4/13, 8:23 AM

Sorry!! Post deleted by author. Setups posted were for a full sprinter.

cecil98 · 7/4/13, 8:36 AM

post deleted by author.

7/4/13, 8:23 AM	#2 Re: ride height adjustment
cecil98 Senior Member Join Date: Jul 2007 Posts: 1,399	Sorry!! Post deleted by author. Setups posted were for a full sprinter. _________________________________________________ Last edited by cecil98; 7/4/13 at 8:39 AM.

7/4/13, 8:36 AM	#3 Re: ride height adjustment
cecil98 Senior Member Join Date: Jul 2007 Posts: 1,399	post deleted by author. _________________________________________________ Last edited by cecil98; 7/4/13 at 8:38 AM.

7/4/13, 12:34 AM	#1 ride height adjustment
diana Member Join Date: Jun 2010 Posts: 58	Hello , Can anyone out there tell me the procedure for setting ride heights I am using 21/2 blocks in the front and 23/4 left rear 23/8 right rear I put the blocks between the axle and the bottom rail , loosen off the torsion stop bolt until it just touches After I do this to the four corners I check my ride height not sure if this is right but I measure from the ground up to the bottom of the frame rail Now if this is correct my ride height is to tall and I have to start turning torsion adjuster bolt to try and lower the car but it is already as low as I can get it Plus how and when do I start adjusting corner weights I have heard you should have 100 lbs more in the left front than the right front and the back should be close to equal. Bailey chassis. Any help would sure be helpful. Hope to hear from someone who knows mini sprint setup Thank you Posted via Mobile Device