Indiana Open Wheel - View Single Post

TQ29m · 4/12/17, 5:00 PM

For you TQ guys, I thought I'd throw this at you, I am currently working on a lower gear R&P than the 5:38 you now have, this one will be in the 6:50 to 1 range, which will allow you to keep your current rear end, and be able to use your current gears, as I stated, this won't be done soon, but if all goes well, I should have at least one available by mid season, you can PM me on here, for an estimated cost, also remember this is quite a machining process, plus I may have to install it for you, but I'll keep the cost as low as I can, I already have quite a bit of cost in tooling, but if you have any questions, don't hesitate to ask. Bob

4/12/17, 5:00 PM	#1 Winters midget lower R&P in works!
TQ29m Senior Member Join Date: Aug 2008 Posts: 6,582	For you TQ guys, I thought I'd throw this at you, I am currently working on a lower gear R&P than the 5:38 you now have, this one will be in the 6:50 to 1 range, which will allow you to keep your current rear end, and be able to use your current gears, as I stated, this won't be done soon, but if all goes well, I should have at least one available by mid season, you can PM me on here, for an estimated cost, also remember this is quite a machining process, plus I may have to install it for you, but I'll keep the cost as low as I can, I already have quite a bit of cost in tooling, but if you have any questions, don't hesitate to ask. Bob __________________ "Being old, isn't half as much fun, as getting there"! Ole Robert I!