our driver is 270 lbs.We run Suzuki 1000c.c.Bailey chassis and we call our class Lightning Sprints
Because of our weight issue it was suggested we run 2 1/2" blocking in the front and
2 3/4" - 2 3/8" in the rear. So when we block with these size blocks it will set our ride heights.Now we want to fine tune corner weights We start adjusting the torsion stops
and we find out our ride heights are shot. Also when we block we turn the torsion stop till it just touches and lock it down. At this point we can only increase our turns and are not able to subtract any turns.
Very unclear on this point and sure could use some help. I had thought that a web site like this would have tons of people offering advice. I need to set the car up tomorrow, for Saturday race.
Please help.
Thank you

Posted via Mobile Device