Lifter Valley Vents
 

I had questions about the crankcase vents that mount a U shape tube, on the lower injection plate (center plate) and the filter mounts on the tube down about the water pump or so (looks to be 1.25-1.5" dia. tube).

I have seen them before, but not how the tube is mounted to the injection plate.
Any info of who may make these parts or photos would be great!!

Thanks,

Re: Lifter Valley Vents
 

Not sure how they how they hook it into that opening. All I can say is we just used a piece of fuel line and earls fittings. It has kept our motor from blowing oil. Before we opened it up it would just cover the top of the motor in oil. I tried venting it into the oil tank it still just blew oil out of the valve covers every where. And yes the motor was fresh.

Re: Lifter Valley Vents
 

Here you can see the clamp that bolts to the
intake. This motor was updated last year.
I don't know the engine builder's supplier.

http://pic100.picturetrail.com/VOL72.../395710066.jpg

Re: Lifter Valley Vents
 

That is exactly what I am looking to do... I have been looking at alot of engine ads and none of them have had a good photo.

thanks,

Re: Lifter Valley Vents
 

Wesmar or Gaerte sell a kit they are not the same size.