Indiana Open Wheel - Complete Sprintcar/ Midget Sellout

2006 Beast Pavement Roller - Sprint
Less than 6 races since NEW. Fresh (0 races since rebuild) KSE steering gear, Winters, ARS gas adj, Revcon, Eibach, Ultrashield FC, Racebolt... Everything but engine. All good equipment. Plus spares, shocks, springs, bars, wheels, wheel wrench, bead breaker, ect. MANY spares.

$14,000 O.B.O.

2007 DRC Roller - Sprint. NEW Never been on the track.
KSE, Winters, ARS, Kirkey, Sanders.

$8,500 O.B.O.

'05 Hawk 4 coil w/ anti roll bars wide body pavement car - Midget
Winters rear w/ internal coupler - ti lower - thermal coating
Lee steering w/ internal reservoir
Penske adjustable shocks - fresh
Eibach Springs - new
New style 4 piston Wilwood calipers
Light weight coated rotors
Tilton master cylinder
Race Bolt
MPD driveline
MPD front end
Adjustable front axle w/ ti king pins
Autometer Glow guages
Stainless steel nerfs
Kirkey light weight seat
TelTac II

Rearend, steering gear and pump fresh 6 races ago. EVERYTHING else brand NEW 6 races ago. Never bent, flipped or in the wall. There is no junk on this car. Everything is top notch.

Ford - Fontana Block - 0 races since complete rebuild

New JE pistons, 6 races since new Yates head, new ti valves, new springs, new retainers, new keepers, new rings, new pins, new bearings, ti rods, Kinsler Injection, Kinser carbon fiber air box, MagTech mag (6 races since all new insides), fresh KSE water pump (rebuilt by KSE). Have dyno sheets and all receipts. Very strong engine.

Spares -front axle, Mopar motor plate, wheel wrench, gears, springs, front bumper, 2 hoods, 3 noses, radius rods, jacobs ladder, king pins, plus more....

Roller - $10K
Engine - $8K
Complete plus all spares - $16K

46' Haulmark Race Trailer - Gooseneck
Tri axle, 15,000 GVWR, breaker box, air lines, inside & outside lights, E-Track, diamond plate/ carpeted.

$10k

Large pit cart that will hold a complete midget front end, rear end, fuel jugs, scales, jack, jack stands, portable welder, radius rods, arelsol cans and plenty of storage for gears, oil, springs, shocks, ect... It is wired for 110 with multiple outlets built in. There is a built in ladder and a walk on roof. The tool chest is a Craftsman 14 drawer ball bearing locking chest. The total length is 90" x 78"T x 36"W. The box is painted silver. Makes loading and un loading a snap.

$2,500

Also Available:
~ Hot Setup Engine Heater
~ Longacre Scale System

Contact Shawn at:
937.572.1006
ShawnNorrisPR@aol.com