Jrp4554 (Offline)
#1
4/25/13 10:07 PM
What's a good starting gear for twin cities?. I heard the banking has changed. Thanks in advance
Posted via Mobile Device
treecitytornado (Offline)
#3
4/26/13 6:37 AM
I wouldn't run a 9.1 Unless you are going to play huggy pole. I'd go with somewhere between an 8.6 To an 8.9.
J.T.
Posted via Mobile Device
goodoleboy24 (Offline)
#4
4/26/13 7:34 AM
I know of about 12 guys that ran 9.10 last week and that was the right gear
Posted via Mobile Device
SP Motorsports (Offline)
#6
4/26/13 10:31 AM
When I ran there prior to the track changes, I ran a 9.1. That's in an acro rear end. I think some even ran a 9.4.
Perhaps the 8.6 to 8.9 was meant for a winters rear end, but that's really tall for an acro.
SP Motorsports (Offline)
#8
4/26/13 12:47 PM
Not at this point. The car is for sale and we have a potential buyer. If that falls through, We'll list it publically.
Posted via Mobile Device
TQ29m (Offline)
#9
4/26/13 12:56 PM
In the past I've ran everything from an 8.6 to a 10.12 with a Winters, that track will really fool ya, when it was a higher bank, you needed a 10.12 just to get up off/out of the turns, and 3-4 was a buggar, you really had to diamond it a lot, to get up on the front straight, then what RR and stagger you runnin, that's a big figure also, big difference between a 71-74, or a 68-69 RR. A 9.1 will keep the Rpm in a safe zone. Ya gotta start somewhere, but don't expect it to be the same gear next time. Bob
"Being old, isn't half as much fun, as getting there"! Ole Robert I!
treecitytornado (Offline)
#10
4/26/13 4:44 PM
Bob, was that 10.12 With the 600 engine, turning 12,000 Plus? I NEVER ran anything lower than an 8.9 And always turned 10,700 to 10,900.
Posted via Mobile Device
