IndianaOpenWheel.com Sprint Car & Midget Racing Forum





Register! Forgot Password?
Post Reply
jdull99 (Offline)
  #1 11/30/15 10:34 PM
-12 mid-90s era Gaerte Engine; For Rent.

Ok for indoor racing!!! ...Indy, DuQuoin, Ft Wayne, Tulsa...

100% FRESH...(everything was in the works to run it with local clubs, before the 2.4 "fad"...lol)

BRAND NEW rings, bearings, gaskets, valve springs, rod bolts, etc. Lifters, rockers, etc were all recently updated too.

All the standard professional racecar engine builder procedures: "Surgically" clean (lol), Magnetic Practical Inspected (all the parts that are steel...lol), blue-printed (crank, rods, valve stems & guides, align-bore, valve spring height, valve to piston clearence, etc, etc. measured to spec - NOT assembled with "plasti-gauge"!), cylinders honed, block & head surfaced, piston-pins fitted, rings "gapped", "competition valve job", etc, etc. (if I didn't list it, just ask!)

$599 to rent per track day. (Includes my prep-time labor/oil change for multi-day events)

EVERYTHING available to install in your car: oil pump to motor plate (narrow-body Stealth), air-filter to pan. All fuel set-ups & oil lines. Supported at fire-off & track-side.

Come check it out now; to see exactly what you would be getting. I would LOVE to see this engine on track again after all the time, effort, money, etc. put into it...

Jason Dull
815 494 6002
jdull99@hotmail.com
Steel$ & Deal$ Swap Meet & Car Shows (next location; TBD...)
jdull99 (Offline)
  #2 12/13/15 11:31 PM
ttt

Jason Dull
815 494 6002
jdull99@hotmail.com
Steel$ & Deal$ Swap Meet & Car Shows (next location; TBD...)
Post Reply