I'm looking for someone that can ethier modify my honda header or make me a new one. I had to move the engine over when I changed the rear end off set and now the header curves down where the steering bar runs. If possible, all I need is to have it cut were it turns down and have it angle out more to clear. Any help I would appreciate, it's crunch time now.

Is it stainless or ms? Where are located?

Posted via Mobile Device

Steel, Martinsville, Indiana, 30 minutes south of Indianapolis. I was hoping someone could cut the tubes where they 90 deg down and make them only angle down approx 45 deg, that would give us the room we need. Thanks Dan

Is header in good condition and uncoated were located in Bloomington

Posted via Mobile Device