Home | Register | Quick Links | FAQ | Donate | Contact |
Indiana Open Wheel
> Indiana Open Wheel Forum
>
Parts for DLH chassis
|
Thread Tools |
2/20/18, 10:14 AM |
#1
Parts for DLH chassis
|
|
Member
Join Date: Nov 2009 Posts: 49 |
So i was wondering where you would get parts for this car that fits rear arms and all that stuff o was told it took standsrd midget parts but not sure all midgets are the same
|
|
|
2/20/18, 10:49 AM | #2 | |
Senior Member
Join Date: Nov 2007 Posts: 1,619 |
Standard xxx, stealth, TCR front axle.
Rear arms takes a offset left rear but could updated to run standard stuff. Nerf bars might need to be fabricated but not a big deal. |
|
|
2/20/18, 11:34 AM | #3 | |
Member
Join Date: Nov 2009 Posts: 49 |
I was tokd it was jim gardners old car i think he ssid you had it to i gueds ar one point. Ok so would stuff from spike work hoping to judt be able to bolt 90 percent of ehst i have on it less fab work would be nice
|
|
|
2/20/18, 12:26 PM |
#4
Re: Parts for DLH chassis
|
||
Senior Member
Join Date: Jul 2007 Posts: 566 |
Mark, that car takes a standard M&W right rear arm, and I used a bailey RR arm and flipped it upside down for the left rear to get the offset (to clear the brake rotor) and length to work. Get a standard triple x front axle. I'm sure you can find someone local to make your bumpers and nerfs, I made my own.
The only thing to watch on that car is that all of the threaded bungs in the chassis for the suspension are 7/16"-20 and all midget components are 1/2"-20. So call Rod End Supply to get the exact rod ends you need (7/16" bore, 1/2" shank for the ends that mount to the chassis, and 1/2" bore, 1/2" shank for the suspension components) and they will take care of you. Get 140 lb coil springs for the front, run 800/825 bars in the rear. Block it at 2-1/2 inches in the front and 3-1/2 in the rear (use a 2-1/2 block in left rear- raised rail car) and hold on tight.
__________________
Jim Gardner
_________________________________________________
Last edited by Jim Gardner; 2/20/18 at 6:11 PM. |
||
|
2/20/18, 1:05 PM | #5 | |
Member
Join Date: Nov 2009 Posts: 49 |
Sweet thank you that the info i need going to get it friday it looked like it shoukd take a 16 inch seat. I know baily is in the process of redoing there stuff the last u taked to him he seem to make me think they dont have there older stuff. I have a guy that has a DLH and he said he had some arms he could sell me and coukd get me some mesurements.
The other thing was its has a gxsr in it and i am running the r1 he told me andy made his mounts i am running foz chassis universal mounts now will they work |
|
|
2/20/18, 1:07 PM | #6 | |
Member
Join Date: Nov 2009 Posts: 49 |
Also on the chassis side would i be able to run a i believe 19/64 bit thur there than re tap for 1/2 fine thread
|
|
|
Indiana Open Wheel
> Indiana Open Wheel Forum
>
Parts for DLH chassis
|