fasster23 (Offline)
#1
5/9/16 10:37 PM
I need to figure out how to determine what size valve springs I need? They're Isky Tool Room springs that are most likely 1.950 or 2.00 installed height but I've been told you can't measure them on the head without a special tool. Any ideas?
motorhead748 (Offline)
#2
5/10/16 6:34 AM
I'd think you could make a good measurement with a dial caliper.
bobby01 (Offline)
#3
5/10/16 7:44 AM
Use a really good machinist scale
I have been doing it this way for years
Bobby Layne
dirtball (Offline)
#7
5/10/16 1:55 PM
Awesome video, answered a lot of questions.
fasster23 (Offline)
#9
5/11/16 12:28 AM
Dad Bobby Motorhead Sp33dy thanks for the replies. I appreciate the help. That video was good. The micrometer is a neat piece. I think I've got a handle on it. Got an engine builder smarter than me coming by to lend a hand. Thanks again fellas!
fasster23 (Offline)
#10
5/11/16 11:48 PM
Got another question for you guys. What's your opinion on titanium locks and retainers? Are they worth the price? Do they wear that much faster than steel? This is on a non-wing 410 with titanium valves. Thanks