|
Hello guys, please delete if this topic is in the wrong spot.
I am looking for some advice on chassis setup. My main question is, when I block the car to the recommended setup blocks I am running into the issue of very low ride heights. For example my RR height will be around 13.5” to the center of the torsion bar, with the LR around 11 1/4” and the torsion arm almost flat. Measurements are without me in the car, and with around 15 gallons of fuel in the tank.
21 Triple X Chassis
305 engine
3 1/2” RF block
4” RR block
-1” less on the left side blocks for raised rail
Around 12” stagger and RR spaced out 17-18”
In order to get to the proper ride heights do you go with shorter block heights to achieve the suggested ride heights, or do you evenly crank weight into the stops to raise the height?
Any information and advice is much appreciated!
|