Indiana Open Wheel - View Single Post - -12 mid-90s era Gaerte Engine; For Rent.

jdull99 · 11/30/15, 10:34 PM

-12 mid-90s era Gaerte Engine; For Rent.

Ok for indoor racing!!! ...Indy, DuQuoin, Ft Wayne, Tulsa...

100% FRESH...(everything was in the works to run it with local clubs, before the 2.4 "fad"...lol)

BRAND NEW rings, bearings, gaskets, valve springs, rod bolts, etc. Lifters, rockers, etc were all recently updated too.

All the standard professional racecar engine builder procedures: "Surgically" clean (lol), Magnetic Practical Inspected (all the parts that are steel...lol), blue-printed (crank, rods, valve stems & guides, align-bore, valve spring height, valve to piston clearence, etc, etc. measured to spec - NOT assembled with "plasti-gauge"!), cylinders honed, block & head surfaced, piston-pins fitted, rings "gapped", "competition valve job", etc, etc. (if I didn't list it, just ask!)

$599 to rent per track day. (Includes my prep-time labor/oil change for multi-day events)

EVERYTHING available to install in your car: oil pump to motor plate (narrow-body Stealth), air-filter to pan. All fuel set-ups & oil lines. Supported at fire-off & track-side.

Come check it out now; to see exactly what you would be getting. I would LOVE to see this engine on track again after all the time, effort, money, etc. put into it...

11/30/15, 10:34 PM	#1 -12 mid-90s era Gaerte Engine; For Rent.
jdull99 Senior Member Join Date: Nov 2008 Posts: 5,834	-12 mid-90s era Gaerte Engine; For Rent. Ok for indoor racing!!! ...Indy, DuQuoin, Ft Wayne, Tulsa... 100% FRESH...(everything was in the works to run it with local clubs, before the 2.4 "fad"...lol) BRAND NEW rings, bearings, gaskets, valve springs, rod bolts, etc. Lifters, rockers, etc were all recently updated too. All the standard professional racecar engine builder procedures: "Surgically" clean (lol), Magnetic Practical Inspected (all the parts that are steel...lol), blue-printed (crank, rods, valve stems & guides, align-bore, valve spring height, valve to piston clearence, etc, etc. measured to spec - NOT assembled with "plasti-gauge"!), cylinders honed, block & head surfaced, piston-pins fitted, rings "gapped", "competition valve job", etc, etc. (if I didn't list it, just ask!) $599 to rent per track day. (Includes my prep-time labor/oil change for multi-day events) EVERYTHING available to install in your car: oil pump to motor plate (narrow-body Stealth), air-filter to pan. All fuel set-ups & oil lines. Supported at fire-off & track-side. Come check it out now; to see exactly what you would be getting. I would LOVE to see this engine on track again after all the time, effort, money, etc. put into it... __________________ Jason Dull 815 494 6002 jdull99@hotmail.com Steel$ & Deal$ Swap Meet & Car Shows (next location; TBD...)