|
Not sayin it's the "approved" method, but I am running the same axle, that now has been in use since 1993, and I have never used anything on it, and it shows no signs of wear, and the wheels still slip on and off as easy as they did when it was new. Might be a good idea to use a wire brush on it once in a while, not a powered one, but one that has a wood or plastic handle, and is run by hand, I know manual labor is not in the books anymore, if you can't plug it in, or run it off a battery, ya don't do it, but sometimes you need another power source! Bob
__________________
"Being old, isn't half as much fun, as getting there"! Ole Robert I! 
_________________________________________________
Last edited by TQ29m; 3/25/14 at 11:34 AM.
Reason: add directions
|