Very good points, but for my purpose, not as relevant. I don’t discount the application of power to the ground and am very aware. But for this exercise I wanted some sort of % of loss when comparing...
Anybody know the % loss in hp/trq numbers when the same motor is taken off the engine dyno and then ran in a car on the chassis dyno? Have seen a couple of ASCS motors with chassis dyno numbers, and...
Hello,
Selling some KSE boxes for car owner. Have 4 boxes, 2 internal, 2 external reservoir.
Box #1 has no races since being gone through, .280. Comes with external reservoir. $550
Box #2 has 8...
Curious about this group. Though they’re racing under the ascs banner, are they running ascs spec motors, or is this the challenge cup group with the flat tappet cam deal?
Thanks -
I don't think anyone can say Minarik is not talented or doesn't work hard. Probably more of an attempt at an engineering feat if anything. Though I must agree, it shouldn't be a viable option to make...
This is a complete motor where the long block is 20 races from new, 2 from fresh in a non wing car on a quarter mile track.
3.48x4.035
-Scat crank and rods
-Wiseco pistons
-Jessel...
Hello,
Im gonna throw together a Kunz coil/swaybar front, bar rear car that I have sitting in my garage. Going to run with an ascs 360 - nw obviously. It is a '09-'10 40" setback car, and can run...
Hello,
Im gonna throw together a Kunz coil/swaybar front, bar rear car that I have sitting in my garage. Going to run with an ascs 360 - nw obviously. It is a '09-'10 40" setback car, and can run...
